 |
|
|
|
EVOLUTION VIII-IX - AXLES
///
BACK TO TOP |
|
|
DRIVESHAFT SHOP REAR AXLE HUB KIT
Outer hubs and wheel bearings are supplied to accomodate the larger outer spline and extended ARP studs. From 30 to 32 spline on the 900HP axles and 36 spline on the 1200 HP axles.
2003-2006 Evolution VIII & IX.
MI49,MI52 |
|
DRIVESHAFT SHOP FRONT AXLES
The Driveshaft Shop Level 2 Front Axles feature aerospace grade 32 spline, up from the factory 30 spline, torsional axle bars with a special double temper process, billet inner and outer CV's and are a direct bolt-in to the factory hubs. These axles are complete and ready to install. Price listed is for both axles.
2003-2006 Evolution VIII & IX.
RA9853L2,RA9854L2 |
|
DRIVESHAFT SHOP FRONT AXLE BAR UPGRADE
The factory inner and outer CV housings are very strong (made from 4130 from the factory) but to bump up the HP rating to 800, Driveshaft Shop has made these bars from a high grade aircraft quality material. This kit includes both bars with boots, clamps and grease. Opt to have the axles assembled with DSS's special heat treat and temper to the housings.
2003-2006 Evolution VIII & IX.
MIF1 |
|
OEM MITSUBISHI FRONT INNER AXLES
Genuine OEM Mitsubishi Front Inner Axles.
2003-2006 Evolution VIII & IX.
MR953315,MR953316 |
|
OEM MITSUBISHI FRONT AXLE SHAFT BOOT REPAIR KITS
Genuine OEM Mitsubishi Inner and Outer Front Axle Shaft Boot Repair Kits fits all the Evolution VIII & IX models and can be used on both the driver (LH) and passenger (RH) sides. Price is for one boot kit as pictured.
2003-2006 Evolution VIII & IX.
MN156750 |
|
OEM MITSUBISHI FRONT AXLE SEALS
OEM Mitsubishi Front Axle Seals. Driver and Passenger side.
2003-2006 Evolution VIII & IX.
MD758763,MN132370 |
|
OEM MITSUBISHI AXLE CLIP
OEM Mitsubishi Axle Clip.
2003-2006 Evolution VIII & IX.
MB160387 |
|
OEM MITSUBISHI AXLE NUT, COTTER PIN & WASHER SET
OEM Mitsubishi Axle Nut, Lock Washer and Cotter Pin Set.
Fits both front and rear.
Purchase the whole kit as pictured or individually, as needed.
2003-2006 Evolution VIII & IX CT9A.
[OEM-AXNT]
MB109029(x1),MF472087(x1),MB109025(x1) |
|
|
EVOLUTION VIII-IX - DRIVESHAFT
///
BACK TO TOP |
|
|
DRIVESHAFT SHOP CARBON FIBER DRIVESHAFT
The Driveshaft Shop 2-Piece Carbon Fiber Rear Driveshaft uses a carbon fiber front and rear section with a specially designed hanger bearing and bracket that eliminates the violent hanger lag that occurs when power is put through the factory shaft. These are different for the AYC and non-AYC models.
2003-2006 Evolution VIII & IX.
MISH8-C,MISH9-C |
|
DRIVESHAFT SHOP ALUMINUM DRIVESHAFT
Driveshaft Shop is proud to introduce their new 2-piece driveshaft for the Evolution VIII-IX. This shaft uses an Aluminum front section with a Chromoly rear section with a specially designed hanger bearing and bracket that eliminates the violent hanger lag that occurs when power is put through the factory shaft. These are different for the AYC and non-AYC models.
2003-2006 Evolution VIII & IX.
MISH8,MISH9 |
|
BUSCHUR RACING DRIVESHAFT LOOP
Made of chrome moly, it bolts into existing holes in the car with the side brackets leaving room to fit the buschur 3" exhaust through/past it too. If the front of the u-joint, yoke or driveshaft itself breaks the driveshaft can dig into the pavement or come through the floor and take your legs out. This is meant to prevent that from happening.
Evolution VIII-IX.
BR-EVO-DS-LOOP |
|
STM DRIVE SHAFT CARRIER BEARING SUPPORT BUSHINGS
STM Drive Shaft Carrier Bearing Support Bushings are a direct replacement for your worn-out, factory, rubber bushings giving you a more solid feel overall and helping to keep the driveshaft firmly in place for a smooth rotation.
2001-2006 Evolution 7/8/9.
STM-DSM/EVO-DSCB |
|
DRIVESHAFT BOOT REPAIR KIT
Genuine OEM Mitsubishi Driveshaft Boot Repair Kit fits the Evolution VIII & IX models and 3000GT & Stealth AWD.
2003-2006 Evolution VIII & IX.
MB837572 |
|
STM DRIVESHAFT TO REAR END NUT & BOLT KIT
Comprised of all genuine OEM Mitsubishi hardware, the STM Driveshaft to Rear End Nut & Bolt Kit includes every bolt, nut and washer for a fresh, new install. Available as the entire kit or individually as needed.
2003-2006 Evolution VIII & IX.
STM-KIT-OEM-DSM-EVO89-DSRE
MF450405(x4),MB000938(x4),MB154075(x4) |
|
OEM MITSUBISHI DRIVESHAFT CENTER BEARING INSULATOR
Genuine OEM Mitsubishi Driveshaft Center Bearing Insulator fits the Evolution 8/9 & 2G DSM. Sold individually.
2003-2006 Evolution VIII & IX.
MB837586 |
|
OEM MITSUBISHI DRIVESHAFT WASHER
Genuine OEM Mitsubishi Driveshaft Washer is used on the the Evolution VIII & IX driveshaft and 1G DSM. Also fits the 1G AWD rear axle shaft assembly on the axle cup side.
2003-2006 Evolution VIII & IX.
MT203641 |
|
OEM MITSUBISHI DRIVESHAFT CARRIER BEARING NUT
Genuine OEM Mitsubishi Driveshaft Carrier Bearing Nuts.
2003-2006 Evolution VIII & IX.
MB288653 |
|
OEM MITSUBISHI DRIVESHAFT LOCKING NUT
Genuine OEM Mitsubishi Driveshaft Locking Nut for the Evo 8/9 and 1G/2G DSM.
2003-2006 Evolution VIII & IX.
MA143517 |
|
MITSUBISHI PARTS
Take a look here to see even more OEM parts. STM has a MASSIVE stock of Mitsubishi parts on hand from tiny clips and gaskets to must-have JDM rears. If you can't find what you need, just give us a shout, if Mitsubishi still makes it, we can get it for you!
2003-2006 Mitsubishi Lancer Evolution VIII-IX.
MITSUBISHI |
|
|
|
