|
EVOLUTION VIII-IX - MOUNTS & BARS
///
BACK TO TOP |
|
|
BUSCHUR RACING "MOUSTACHE BAR" (REAR DIFF SUPPORT)
This is the Buschur Racing Rear Differential Support, or called by some the "Moustache Bar." This holds the rear differential in place. The rediculously heavy stock bar weighed 15.9 pounds! While the new Buschur piece holds strong at only 3.2 pounds! You can shed almost 13 pounds off the car with this one piece!
Evolution VIII-IX.
BR-EVO-MOUSTACHE |
|
TORQUE SOLUTION MUSTACHE BAR ELIMINATOR KIT
Designed to eliminate that annoying rear diff "clunk" under hard shifts from the rear of your car. Made from 100% billet 6061 aluminum and CNC machined for accurate tolerances. The urethane bushings are less harsh and transmit less feedback into the cabin then the solid bushings. Bushings are REQUIRED for install, but you can purchase just the mount if you already have them.
Evolution VIII-IX.
TS-EV8-005,TS-EV8-004,TS-EV8-003 |
|
BUSCHUR RACING REAR DIFF SIDE SUPPORT BRACKETS
This is Buschur's lightweight, billet aluminum solution to those rusted chunks of steel that currently bolt to the sides of your rear diff. These new Side Differential Support Brackets weighed in at only 4.25 pounds and completely replace the stock part with no need to replace the rubber bushing.
Evolution VIII-IX.
BR-EVO-DIFF-SUP |
|
BUSCHUR RACING FRONT CROSS MEMBER BRACE
This is designed to replace the member that is located under the front of your Evolution that runs front to rear. Made of lightweight chromoly tubing this item saves 6.2 pounds of weight from the stock member.
Evolution VIII-IX.
BR-EVO-CROSSM |
|
BUSCHUR RACING DRIVESHAFT LOOP
Made of chrome moly, it bolts into existing holes in the car with the side brackets leaving room to fit the buschur 3" exhaust through/past it too. If the front of the u-joint, yoke or driveshaft itself breaks the driveshaft can dig into the pavement or come through the floor and take your legs out. This is meant to prevent that from happening.
Evolution VIII-IX.
BR-EVO-DS-LOOP |
|
OEM MITSUBISHI DRIVER SIDE TRANSMISSION/MOTOR MOUNTS
Genuine OEM Mitsubishi Driver Side Transmission/Engine Motor Mount. Mounts are different for 5-Speed & 6-Speed.
2003-2006 Evolution VIII & IX (5-Speed)
2003-2006 Evolution VIII & IX (6-Speed)
MR491558,MN100000 |
|
OEM MITSUBISHI REAR ENGINE/TRANSMISSION MOUNT BRACKET
Genuine OEM Mitsubishi Rear Engine/Transmission Mount Bracket.
2003-2006 Evolution VIII & IX.
MR554652 |
|
OEM MITSUBISHI REAR TRANSMISSION/ENGINE MOUNT BRACKET
Genuine OEM Mitsubishi Rear Transmission/Engine Mount Bracket.
2003-2006 Evolution VIII & IX.
1092A024 |
|
5-SPEED TRANSMISSION CASE MOUNT BRACKET
Genuine OEM Mitsubishi Transmission Case Mount Bracket for the 6-Speed Mitsubishi Lancer Evolution VIII-IX.
2005-2006 Evolution VIII-IX (6-Speed)
1092A004 |
|
OEM EVO 8/9 FRONT ENGINE MOUNT / TRANSMISSION BRACKET
Genuine OEM Mitsubishi Evo 8/9 Front Engine Mount Bracket / Transmission Roll Stopper fits all 2003-2006 Mitsubishi Lancer Evolution VIII-IX GSR, RS, SE, & MR models..
2003-2006 Evolution VIII & IX.
MD759723 |
|
|
EVOLUTION VIII-IX - DRIVESHAFT & DIFF BUSHINGS
///
BACK TO TOP |
|
|
STM DRIVE SHAFT CARRIER BEARING SUPPORT BUSHINGS
STM Drive Shaft Carrier Bearing Support Bushings are a direct replacement for your worn-out, factory, rubber bushings giving you a more solid feel overall and helping to keep the driveshaft firmly in place for a smooth rotation.
2001-2006 Evolution 7/8/9.
STM-DSM/EVO-DSCB |
|
DRIVE SHAFT CARRIER BEARING SUPPORT BUSHINGS
Torque Solution Drive Shaft Center Support Bushings will replace the OEM Rubber mounts with billet aluminum pieces. Doing so will allow for reduced wheel hop, improved acceleration and better E.T's. The mounts keep the propeller shaft from moving under hard acceleration, stopping and turning giving you optimal performance 100% of the time.
2003-2006 Evolution VIII-IX.
TS-EV-DSB |
|
ENERGY SUSPENSION REAR DIFF BUSHING SET
Sick of that "Thunk" when you shift hard into the next gear? These will take care of that. Energy Suspension's HYPER-FLEX performance polyurethane rear differential/moustache bar bushing set is made in the USA.
2003-2006 Evolution VIII-IX.
5.1108G,5.1108R |
|
WHITELINE EVO 8/9 REAR DIFFERENTIAL MOUNT BUSHINGS
The Whiteline Rear Differential Mount Bushings fits all the Evolution VIII & IX models and ensure pinion angles are maintained while delivering an improved gear shift resulting in reduced initial torque loss and greater power transfer to the wheels.
2003-2006 Evolution VIII-IX.
W0592 |
|
OEM MITSUBISHI REAR DIFF MOUNT BAR BUSHING
Genuine OEM Mitsubishi Rear Diff Mount Bar Bushing fits all Evolution VIII & IX models.
2003-2006 Evolution VIII & IX.
MB809334 |
|
|
EVOLUTION VIII-IX - SHIFTER BUSHINGS
///
BACK TO TOP |
|
|
STM UNDER-HOOD SHIFTER CABLE BUSHINGS
The STM Shifter Cable Bushings will give you a firm, more consistent shift. These are made of aluminum and anodized black for durability. Upon install, we recommend a touch of anti-seize on the shaft to help reduce friction. 5-Speed Transmission only.
2003-2006 Evolution VIII-IX. (5-Speed).
STM-EVO89-UHSB5 |
|
BUSCHUR RACING SHIFTER CABLE BUSHINGS
The stock, rubber bushings can tear and wear, leaving you unable to put the car in gear! These BR bushings are made of hardened aluminum, they are cheaper and half the weight of competitor's bushing sets.
Evolution VIII-IX. (6-Speed)
BR-EVO-SHCB5,BR-EVO-SHCB6 |
|
TORQUE SOLUTION SHIFTER CABLE BUSHINGS
Developed to perform under the most extreme conditions, Torque Solution Shock Factor Shifter Bushings bridge the gap between ordinary aluminum, brass, and cheap plastics used in current aftermarket shifter bushings by offering a unique Delrin, specifically chosen by Torque Solution engineers to ensure product performance and reliability while drastically reducing shifter end play allowing for crisper, more precise shifts.
Evolution VIII-IX. (6-Speed)
TS-SCB-300 |
|
TORQUE SOLUTION SHIFTER BASE BUSHINGS
Torque Solution shifter base bushing kit replaces the OEM rubber bushings on the bottom of the shifter providing a more stable shifter platform and mounting points. This yeilds improved shifting feel and characteristics for years of enjoyment.
2003-2006 Evolution VIII-IX.
TS-BB-004 |
|
ENERGY SUSPENSION SHIFTER BASE BUSHINGS
Energy Suspension's Shift Stabilizer Bushing will improve the shift feel and responsiveness on your car. This easily installed kit eliminates the soft rubber factory change extension bushings and will work with the factory shifter and other aftermarket shifters.
2003-2006 Evolution VIII-IX.
5.1102G,5.1102R |
|
MITSUBISHI PARTS
Take a look here to see even more OEM parts. STM has a MASSIVE stock of Mitsubishi parts on hand from tiny clips and gaskets to must-have JDM rears. If you can't find what you need, just give us a shout, if Mitsubishi still makes it, we can get it for you!
2003-2006 Mitsubishi Lancer Evolution VIII-IX.
MITSUBISHI |
|
