 |
|
|
|
EVOLUTION X - AXLES
///
BACK TO TOP |
|
|
DRIVESHAFT SHOP DIRECT-FIT REAR AXLES
Driveshaft Shop Level 5 Direct Fit Axles for the Evo X feature aerospace grade 32 spline, up from the factory 30 spline, torsional axle bars with a special double temper process, billet inner and outer CV's and are a direct bolt-in to the factory hubs. These axles are complete and ready to install. Price listed is for both axles.
2008-2015 Evolution X.
RA9910L5,RA9911L5 |
|
DSS LEVEL 5 REAR AXLES WITH EVO 8/9 REAR DIFF CONVERSION
These Driveshaft Shop Level 5 Direct Fit Rear Axles are designed for the Evo X with the Evo 8/9 rear differential conversion. These axles are complete and ready to install. Price listed is for both axles.
2008-2015 Evolution X.
(with Evo 8/9 Diff Conversion)
RA9907X5,RA9908X5 |
|
|
EVOLUTION X - DRIVESHAFT
///
BACK TO TOP |
|
|
DRIVESHAFT SHOP CARBON FIBER DRIVESHAFT
The Driveshaft Shop 2-Piece Carbon Fiber Rear Driveshaft uses a carbon fiber front and rear section with a specially designed hanger bearing and bracket that eliminates the violent hanger lag that occurs when power is put through the factory shaft.
2008-2015 Evolution X.
MISH10-C |
|
DRIVESHAFT SHOP ALUMINUM DRIVESHAFT
Driveshaft Shop is proud to introduce their new 2-piece driveshaft for the Evolution X. This shaft uses an Aluminum front section with a Chromoly rear section with a specially designed hanger bearing and bracket that eliminates the violent hanger lag that occurs when power is put through the factory shaft.
2008-2015 Evolution X.
MISH10-A |
|
OEM MITSUBISHI EVO X DRIVESHAFT/DIFF LOCKING NUT
Genuine OEM Mitsubishi Driveshaft/Diff Locking Nut fits all 2008-2015 Evolution X models.
2008-2015 Evolution X.
MA143517 |
|
|
EVOLUTION X - BUSHINGS
///
BACK TO TOP |
|
|
TORQUE SOLUTION EVO X SOLID BILLET REAR DIFFERENTIAL MOUNTS
The Torque Solution Solid Billet Rear Differential Mount and Side Inserts for the 2008-2015 Evolution X will eliminate movement of the rear end in the subframe giving you better feedback, sharper response, more predictability on throttle input, along with eliminating that annoying clunking during hard shifts.
2008-2015 Evolution X.
TS-EVX-001,TS-EVX-004,TS-EVX-005 |
|
TORQUE SOLUTION EVO X URETHANE SIDE INSERTS AND BILLET MOUNT
By replacing your stock rubber mounts with the polyurethane bushings, you are able to get rid of the unwanted slop and flexing of the stock unit which allows for the power to go into rotating the tires, instead of flexing the rubber.
2008-2015 Evolution X.
TS-EVX-001,TS-EVX-002,TS-EVX-003 |
|
STM DRIVE SHAFT CARRIER BEARING SUPPORT BUSHINGS
STM Drive Shaft Carrier Bearing Support Bushings are a direct replacement for your worn-out, factory, rubber bushings giving you a more solid feel overall and helping to keep the driveshaft firmly in place for a smooth rotation.
2008-2015 Evolution X.
STM-DSM/EVO-DSCB |
|
DRIVE SHAFT CARRIER BEARING SUPPORT BUSHINGS
Torque Solution Drive Shaft Center Support Bushings will replace the OEM Rubber mounts with billet aluminum pieces. Doing so will allow for reduced wheel hop, improved acceleration and better E.T's. The mounts keep the propeller shaft from moving under hard acceleration, stopping and turning giving you optimal performance 100% of the time.
2008-2015 Evolution X.
TS-EV-DSB |
|
|
EVOLUTION X - SEALS
///
BACK TO TOP |
|
|
OEM MITSUBISHI EVO X FRONT AXLE SEAL (RH) (TRANSFER CASE OUTPUT)
Genuine OEM Mitsubishi Transfer Case Output Front Axle Seal fits all the Evolution X models. For the USDM passenger side (RH) front axle.
2008-2015 Evolution X.
3200A145 |
|
OEM MITSUBISHI EVO X FRONT AXLE SEAL (LH) (TRANSMISSION OUTPUT)
Genuine OEM Mitsubishi Transmission Output Front Axle Seal fits all the Evolution X models. For the USDM driver side (LH) front axle.
2008-2015 Evolution X.
MN132370 |
|
OEM MITSUBISHI EVO X REAR AXLE SEAL (LH) (DIFF OUTPUT)
The Genuine OEM Mitsubishi Rear Diff Axle Seal fits all the Evolution X models. For the USDM driver side (LH) rear axle.
2008-2015 Evolution X.
3515A049 |
|
OEM MITSUBISHI EVO X REAR TRANSFER CASE OUTPUT SEAL
Genuine OEM Mitsubishi Rear Transfer Case Output Seal to Driveshaft fits all the Evolution X models.
2008-2015 Evolution X.
3200A105 |
|
OEM MITSUBISHI EVO X REAR DIFFERENTIAL OIL SEAL
Genuine OEM Mitsubishi Rear Diff Drive Pinion Oil Seal fits all Evolution X models.
2008-2015 Evolution X.
MB393929 |
|
MITSUBISHI PARTS
Take a look here to see even more OEM parts. If you can't find what you need, just give us a call anytime, and we can track down it for you!
2008-2015 Mitsubishi Lancer Evolution X 4B11.
MITSUBISHI |
|
|
|
